I WISH SCRAPPIN' KIT CONTINUED

4 projects made so far!

GIFT CARD HOLDER

It was my goal to draw out a template to use as a guide line for making this gift card holder.

So here is my first attempt with this pattern.

Cut CARD STOCK to 10 7/8" x 2 3/4".

Score at 3 3/4", 4", 7 7/8" & 8 1/8".  

Cut 2 pieces of DESIGNER SERIES PAPER to 3 3/4" x 6"

Score at 2" & 4 1/2", turn and score at 1/4".

Use the 1 1/4" CIRCLE PUNCH to punch out a half circle from top/front of both pockets.  Remove the two outside corners as shown in photo below.

Fold pocket with longer side tucked in.  Use SNAIL to glue together.

SNAIL pockets together, seam to seam.

Adhere DESIGNER SERIES PAPER pockets into gift card holder using STICKY STRIP.

Apply 4 STAMPIN' DIMENSIONALS to the front flap of the gift card holder.

Cut three coordinating colored CARD STOCK pieces to apply to the front of the holder using the STAMPIN' DIMENSIONALS already in place.

Whisper White ~ 2 1/2" x 3 1/2"

Chocolate Chip ~ 2 3/8" x 3 3/8"

Old Olive ~ 2 1/4" x 3 1/4"

To open and close the holder, the smaller panel  folds in between the larger panel and the card front.  

This is what it should look like from the side.

Aside from the Chocolate Chip CARD STOCK (the textured card stock is not stiff enough to hold the holder together properly) I used for the base of the project, every item used was from the I WISH SCRAPPIN' KIT.